new to the forum, please help

G

GratefulUndead

New Member
ok, so i just finished my second build and im having a problem i havent run into yet. basically when i release the clutch lever to engage and start, nothing happens. i did everything with care and even better this time around. i don't understand why the clutch will not engage. tried adjusting but not sure if im doing it correctly. i have been searching for an answer for about a week. thanks.:-||
 
Search the clutch threads in classic motorbicycle posts.
Norm has a great thread on adjusting the clutch.
 
I think I'm having the Same problem. I think it is the internals sticking.at least I think that's what's happening with mine. Just built mine 2days ago got everything on tried to roll bike and engage clutch to turn over nothing locked up tight. Don't even have fuel in it yet. Still trying to figure out what to do. The only thing I can think of is a few drops of 2stroke piling cylinder to help internals move. Let me know if your successful with your build
 
Well basically I just had the brass screw thing pulling the clutch lever to tight. I lossened up and brought it down about 1/8 inch and now clutch engages no problem.
 
Ralord1977 said:
I think I'm having the Same problem. I think it is the internals sticking.at least I think that's what's happening with mine. Just built mine 2days ago got everything on tried to roll bike and engage clutch to turn over nothing locked up tight. Don't even have fuel in it yet. Still trying to figure out what to do. The only thing I can think of is a few drops of 2stroke piling cylinder to help internals move. Let me know if your successful with your build
Click to expand...

usual cause for this is the chain is stuck on the drive sprocket - take that cover off & look
 
You must log in or register to reply here.
Back
Top