Electronic Guru's, little help please

L

Lazy Dog

Member
I'm stuck on a never ending quest to charge a li-ion battery pack. After months of teaching myself electronics, I managed to build an internally mounted alternator(modified magnito), rectifier, high powered LED driver, and I got a cmb/pcb working to safely charge and discharge li-ion's at the same time. Last thing I need is a boost converter that can get up to 16-17v.

I think I got it, can someone please look this over for me.(so I can at least be ready for the explosion)

The only thing I have no idea about is, is this going to be capable of sustaining the correct output 16volts or is it still going to vary with RPM? I think it's just a step up converter not really a boost puck.
 

Attachments

  • boost converter.jpg
    boost converter.jpg
    113.8 KB · Views: 151
A Li-Ion charger needs to be computer controlled. If you put too much current into a Li-Ion, you will fry it. If you don't taper off the current as you reach the full-charge state, you will fry it. If your charging voltage is too high, like how most NiCad and NiMH batteries are charged - you guessed it - you will fry it. Also, if you just constantly feed it a voltage like how lead-acid batteries are maintained, it will ruin its longevity.
 
I know that's what the cmb/pcb "charge management board" is for, I'm already using li-ion pack i built. If over charged or decharged too much they burst into flames.

4.20V Max per cell for charging and 2.30V per cell for discharge
 
You must log in or register to reply here.
Back
Top