Chopperjoe

[chopperjoe]

Hello new to forum, and new to motorbikes, having fun with it. my problem is a hairline crack in the float on 48cc grubee, called Kings motorbikes about issue, to no avail, sounded helpful on phone waited 2 weeks for delivery still no replacement, called again a sincere sounding apoligy, been a week still no float. the part was bad from day 1. any one have any luck with kings on warranty parts. or is there a good glue or epoxy to use to seal the leak thnx chopper

 

[azbill]

welcome
i have sealed a badly-seamed one with a soldering iron...
just make sure it is fully drained before attempting

 

[Bikeguy Joe]

Welcome!

Any float from any seller will work.

 

[chopperjoe]

Welcome!

Any float from any seller will work.

thanks for the advice, i was thinking about the solder iron, was also giong to try farm and fleet for a replacement, they seem to have good selection of small engine parts. I figure if its pretty close to same size it should work.trying my best to get around this web site, might take a little time