One of my crank case bearings is failing. I have a dax gen iv motor with 1300 miles on it. I tore down the engine to replace all the case bearings with SKF 6202 2RS-C3's that I've been anxiously waiting to install in one of my motors. When I split the case the bearing that is suspect to be failing came out with the crank and is stuck on the crank shaft. What methods can I use to remove this bearing? Also after inspecting the other bearings on the case one of the clutch case bearings was also starting to fail. Other than that both of my Gen IV motors are awesome and I will never buy anything else..... I just may replace the bearings from the get go.
Thanks in advance for any help!
Thanks in advance for any help!