Hey all, I'm new to the forum. I'm looking to use this engine for a FD bike. I removed the engine from an old edger i found sitting on the side of my boat. Not sure what kind of edger it was but the air filter says craftsman on it so I'm guessing its a craftsman. Wondering if anyone can identify the engine.
Another question I have is about the output shaft. Its a 5/8 shaft with a woodruff key but its not threaded on the end. How would I attach a drive roller to this type of output shaft?
Another question I have is about the output shaft. Its a 5/8 shaft with a woodruff key but its not threaded on the end. How would I attach a drive roller to this type of output shaft?
Attachments
-
809.5 KB Views: 190
-
761.5 KB Views: 183
-
757.4 KB Views: 211
-
742.7 KB Views: 198
Last edited: