part two husheng recoil fix. as i found out when it came to bits, i could have used a much smaller drill, to get the head of the screw off. you only need a drill a little larger than the thread of the screw. ie. 8 mm. but i did not know this at first as it looked like a thick special screw. It was of course a bush. which fits in the drive plastic peice. this drive plastic fitting you will notice it has inserted in it something like an O ring this appears to lubricate and centralise the bush.
now if you make a mess of the skilled drilling part, all is not lost, even i was surprised i managed to do it, playing by ear as i went along. all you need to do is putt a suitable bolt right through the whole unit, nice shallow head on the outside for apperance sake,then a nylon lock nut on the inside. this is the easy way, but try to keep all the items the bolt goes though, as close tollerance as possible, this helps with allignment and fitting. I like a challenge so did it the hard engineers way.
assembly this was a bit of a pig, coiling the spring in its housing easy, just mahe sure there is a nice bend in the middle end of the spring so it holds firm in the slot of the plastic boss. NOW when locating the spring onto to the central bearing boss. if you keep it at a slight angle you can see underneath it and locate the end of the spring in the slot, now the spring holds in the housing pretty good due to the built in tension of the spring,
the main drive part with the drive pins, can be put in last, as you can see through the centre hole as an extra check. now as there is no screw through the centre yet, it is to tilt the drive part and locate it in its correct position. note the position of all the pieces before out take things apart. FROM THE START. another tip to eliminate cord breakages, go to a chandlers and get some stainless steel braided cable they use for dingys, you only need somthing a bit thinner than the normal cord, use solderless cable nipples to secure the ends, two on each end foe extra security. should last a life time. maybe the hond version wiil unscew, a saw a parts list of one, and it showed a repacement screw looked like a thick self tapping screw, so maybe the honda is made to come apart, as member stated the part No of the honda is 2800-zm7-003 this is identical to the huasheng, not sure about the holding screw though. good safe riding.