OK,
I am new to this. But I have read all the threads I could find before writing this thread.
My rear wheel sprocket seems to stick out so that my chain does not have enough clearance. The chain appears it will rub up against the frame. I have dished the sprocket correctly. If I dished it inward it may give me more room but it sounds that this would be the wrong thing to do.
I have added two additional washers on the axle post and could add two more but this would but some stress on the rear frame and I am not sure if that is the best solution.
I wish that my rag joints were a little thinner ... this would give me more room.
Is there a way to tighten my spokes and draw the hub further away?
The Onex will have a 4 stroke HS.
I am new to this. But I have read all the threads I could find before writing this thread.
My rear wheel sprocket seems to stick out so that my chain does not have enough clearance. The chain appears it will rub up against the frame. I have dished the sprocket correctly. If I dished it inward it may give me more room but it sounds that this would be the wrong thing to do.
I have added two additional washers on the axle post and could add two more but this would but some stress on the rear frame and I am not sure if that is the best solution.
I wish that my rag joints were a little thinner ... this would give me more room.
Is there a way to tighten my spokes and draw the hub further away?
The Onex will have a 4 stroke HS.