Hello all, I have been building this thing for a few weeks now due to lack of time and mechanical abilities. I finally got everything going, chain shortened was my biggest hurdle other than having to buy a drill and dremel kit. I think I'm only having 2 issues and hope someone can assist. I have searched the forums to no avail.
Problem 1: When I turn the throttle, the cable does nothing. If I remove it from the carb and hold the slide the throttle moves fine. I read about shortening the cable and really hope i don't have to do that since I have never soldered before. Also, this is the first time I have touched a carburetor so I could have installed the whole thing wrong
Problem 2: The motor starts, rather easily actually which is awesome, but idles really low I think. I get this impression because when I pull in the clutch with the engine running it idles really high.
Any help would be greatly appreciated and re payed with my gratitude, which is exchangeable for cold beers in the montrose/heights area of Houston.
Problem 1: When I turn the throttle, the cable does nothing. If I remove it from the carb and hold the slide the throttle moves fine. I read about shortening the cable and really hope i don't have to do that since I have never soldered before. Also, this is the first time I have touched a carburetor so I could have installed the whole thing wrong
Problem 2: The motor starts, rather easily actually which is awesome, but idles really low I think. I get this impression because when I pull in the clutch with the engine running it idles really high.
Any help would be greatly appreciated and re payed with my gratitude, which is exchangeable for cold beers in the montrose/heights area of Houston.