Bill welded the tab onto the fork leg the brake plate slips into. Now I can paint and assemble the forks and lace the front wheel.
The pivot on the front of the seat Bill bought at the long Beach cycle swap is worn out and I needed to replace it with one that is wider so the seat can slip down over the tube.
So I cut a new bracket from a 1'' X 4'' heavy wall tubing and bolted it to the seat pan.
Then I made a seat mount using 1 1/4'' X 3/8'' thick bar stock welded into 1'' round stock at a 20 degree angle so it is level.
By opening up the slot at the pinch bolt, my mount can slip into place.