Originally Posted by "the prussian" Shop Dogs
Tank during fab ,the brass fitting is from the washing machine section of ace hardware .the torch is a # 4 amd the brazz rod i found best is the cheap red coated stuff.
This photo is a tank i made with mig welder ,if you look close you can see the whole spool of wire this tank took to seal ,braze is deff. Better .
I think on page 1 the picture is from MIG welded the few spots to hold the tank together.
You said something about using a whole spool that would be MIG.
You also mentioned torch and brass rod. I see the torch nozzle in the picture too, but wondered what you did with the flame braze and the brass rod?
Mostly the tank was done with MIG and if I get thick enough or better at using my lowest setting on my MIG, I can try tank sealer too.
You could or maybe are going to add body filler on out side?
Nice going so far!