Transferport

max350 · Sep 27, 2013

An easy way to control the flow into the transfer portarna.du need a propane torch or similar

Caution! do not heat the cylinder too much

http://youtu.be/VlmFEMXYZYY

maniac57 · Sep 29, 2013

Good way to visualize flow patterns if you don't have a smoke pencil
http://www.amazon.com/Smoke-Pencil-Draft-Detector-Puffer/dp/B00746F5HG
Be careful not to get things too hot though! If you're anything like me, you WILL grab the hot part sooner or later....

mew905 · Oct 2, 2013

what exactly are you doing in that video? the only thing I can really see is SEEING where the transfer is aiming, but I dont see any actual modification/control... If this is a simple way to correct transfer angles, then for sure I'd be interested in this.

max350 · Oct 3, 2013

mew905 said:
what exactly are you doing in that video? the only thing I can really see is SEEING where the transfer is aiming, but I dont see any actual modification/control... If this is a simple way to correct transfer angles, then for sure I'd be interested in this.

This a rather crude method to see how the gas flow occurs in the cylinder, what you see is the gas mixture hits the rear cylinder wall. if the angle is wrong in the transfer port gas mixture might end up in the wrong place, such as in the middle of the cylinder instead of the rear wall

Search

Transferport

max350

Active Member

Attachments

maniac57

Old, Fat, and still faster than you

mew905

New Member

max350

Active Member