I've got a 2 stoke scooter I'm working on.
I attached picture so you can see what I'm working with.
I can get it to run, but I can't control the RPMs. I'm not really sure where to attach the throttle cable on this new motor.
I Have a throttle handle and a butterfly valve with a primer bulb on it that I took off of the old motor. but it doesn't fit the new one.
I also can't stop the thing short of pulling the spark plug wire off. Is there a way to stop them or am I going to have to wire in a kill switch on the plug wire?
Anyone have any suggestions?
I attached picture so you can see what I'm working with.
I can get it to run, but I can't control the RPMs. I'm not really sure where to attach the throttle cable on this new motor.
I Have a throttle handle and a butterfly valve with a primer bulb on it that I took off of the old motor. but it doesn't fit the new one.
I also can't stop the thing short of pulling the spark plug wire off. Is there a way to stop them or am I going to have to wire in a kill switch on the plug wire?
Anyone have any suggestions?
Attachments
-
447.6 KB Views: 139