Hey guys,
My rear wheel being maybe 20+ years old has died on me. I should of regreased it but oh well.
I thought to transfer the sprocket over to my other mountain bike rear wheel but the center hub piece is too small for the metal sprocket. So I doubt that the rubber clamping method will keep it center.
Instead of buying a new mountain bike wheel which is apparently 60 bucks, I am just going to get a heavy duty one with a proper axle clamp. I was thinking this from piratecycles: http://www.piratecycles1.com/cbwhw12gasps.html
I then can't decide if I want a 44tooth or 40 tooth.. It's very mountenous/hilly and the 44tooth has been doin great but does slow down goin up. I just put on the new RT carburetor so maybe I could go 40 tooth... I'm not sure
Suggestions?
My rear wheel being maybe 20+ years old has died on me. I should of regreased it but oh well.
I thought to transfer the sprocket over to my other mountain bike rear wheel but the center hub piece is too small for the metal sprocket. So I doubt that the rubber clamping method will keep it center.
Instead of buying a new mountain bike wheel which is apparently 60 bucks, I am just going to get a heavy duty one with a proper axle clamp. I was thinking this from piratecycles: http://www.piratecycles1.com/cbwhw12gasps.html
I then can't decide if I want a 44tooth or 40 tooth.. It's very mountenous/hilly and the 44tooth has been doin great but does slow down goin up. I just put on the new RT carburetor so maybe I could go 40 tooth... I'm not sure
Suggestions?