I recently bought a 49cc bike kit from boygofast on ebay and i am having problems w/ the clutch sprocket i took plate off couple of times and tapped the pin still stuck,should i engage the clutch and take a straight screwdriver and hammer it on the sprocket to break it lose?
engine sprocket stuck
- Thread starter duck
- Start date
is this the drive gear off the motor? got any pics? dont take a hammer and screwdriver to anything! if your trying to remove the pin use a magnet to pull pin out. is the chain binding up on the inside and around the drive gear?
finally figured that part out but now im having problems w/ chain tension ,can u recommend any better ones than the original?
take off the spring from thr clutch cable and make sure the pate is off and pull the cable to the point where the arm willbe tight then tighten the cable and put the plate back on and im sure that it should make the clutch work cause most times its jst that the cable isnt pulling the clutch hard enough to engage it an let the motor lose to run
