I have recently obtained a good used TEC (pre-powersport??) 4-5 hp
engine,and a Comet Torq A Verter cvt;any1 that has knowledge
regarding 'fabbing' a mount for the TEC, and to fit to the left side near,or on the axle of an ATB??
The mount should be similar to the Curry bicycle motor,but for 2 cycle
engine.
Replies can/should include any designs (attached) in bmp,pdf,jpg,etc to help in designing the engine mount somewhat level with the rear axle...
Thanks in advance for any replies!
engine,and a Comet Torq A Verter cvt;any1 that has knowledge
regarding 'fabbing' a mount for the TEC, and to fit to the left side near,or on the axle of an ATB??
The mount should be similar to the Curry bicycle motor,but for 2 cycle
engine.
Replies can/should include any designs (attached) in bmp,pdf,jpg,etc to help in designing the engine mount somewhat level with the rear axle...
Thanks in advance for any replies!
