I've had this kit for a while since the last bike I wanted to put it on got stolen and I didn't want to slap the motor on another bike to have that one stolen due to no garage. Well I moved and have everything together to throw it on a bike. I was doing a dry run making sure everything fit well and to make sure I had everything and when I got to the clutch bell and bushing the bushing just will not go in more than about 1mm. It slides in that far then just gets stuck. This is the bushing I got with the kit, and it has been sitting in an AZ storage room for over a year. I know you are supposed to lubricate them when doing the real install, but will having it just be dry make it get stuck like that or are one of the parts bad?
