Hello, I was hoping to get an idea of what I need to do to get my moterbike running again and thought this would be the place to ask.
I was given a 66cc china girl engine by a friend and it worked for a few hours before the clutch stopped working so I took off the cover that attaches the chain to the engine(this was very hard to do because the buckingbar was pressing against the inside of the cover with lots of pressure) and noticed that the buckingbar was out farther then it should be so I tried to push it back in and it wouldn't budge!
I decided to take the clutch cover off and after getting the clover shaped nut and clutch plate off I noticed that the center Disengaer Shaft(threaded rod that the clover nut screws onto) was pushed in.
So my question is how can I free the center Disengaer Shaft so that it moves back and forth so I can reinstall my buckingbar and get my clutch working again properly?
Thanks for reading!
Regards,
Benji
I was given a 66cc china girl engine by a friend and it worked for a few hours before the clutch stopped working so I took off the cover that attaches the chain to the engine(this was very hard to do because the buckingbar was pressing against the inside of the cover with lots of pressure) and noticed that the buckingbar was out farther then it should be so I tried to push it back in and it wouldn't budge!
I decided to take the clutch cover off and after getting the clover shaped nut and clutch plate off I noticed that the center Disengaer Shaft(threaded rod that the clover nut screws onto) was pushed in.
So my question is how can I free the center Disengaer Shaft so that it moves back and forth so I can reinstall my buckingbar and get my clutch working again properly?
Thanks for reading!
Regards,
Benji