Everything was goin fine,I'm an adult but I am using the bike as my primary mode of transportation for the past 3 or 4 days I have had it.
So today I went across town and chained my bike near the beach when I came back the engine turned over and possibly before it fully stabilized I started up a steep hill, I ended up stopping due to traffic and the engine cut off, after this point I was unable to get it to fully turn over, it will stutter a little and not fully turn on, at one point there was dark colored stuff comeing out of the muffler.
I then waited a few hours and petaled home, there was a steep hill goin down about half way the 6 mile ride so I decided to try one more time to turn it over and it worked. when I got home I stopped the engine and decided to see if I could get it to turn and I had no problem. I then waited a few hours and tried again at this point I could get it to sputter a bit but not fully start.
I am useing 16: 1 mix meaning I mix 8oz per 1gallon of gas so far I have burned about a tank and a half of gas.
Now for the things I know I am doin wrong, I am perhaps riden it a little too hard and I believe its possible 3 in 1 might have been used on the chain.
So what is my move to correct this,? I have been trying to find answers but I cannot.
So today I went across town and chained my bike near the beach when I came back the engine turned over and possibly before it fully stabilized I started up a steep hill, I ended up stopping due to traffic and the engine cut off, after this point I was unable to get it to fully turn over, it will stutter a little and not fully turn on, at one point there was dark colored stuff comeing out of the muffler.
I then waited a few hours and petaled home, there was a steep hill goin down about half way the 6 mile ride so I decided to try one more time to turn it over and it worked. when I got home I stopped the engine and decided to see if I could get it to turn and I had no problem. I then waited a few hours and tried again at this point I could get it to sputter a bit but not fully start.
I am useing 16: 1 mix meaning I mix 8oz per 1gallon of gas so far I have burned about a tank and a half of gas.
Now for the things I know I am doin wrong, I am perhaps riden it a little too hard and I believe its possible 3 in 1 might have been used on the chain.
So what is my move to correct this,? I have been trying to find answers but I cannot.