Lurking and studying stuff here for weeks. Finishing up my first build on a new La Jolla soon and then want to start a build in a Dyno. I am not looking for speed but only pick up so I bought a 50 and a 56 sprocket. The 56 has the same bolt pattern diameter as my existing 44 tooth but the 50 tooth is smaller. ??
Should I re drill the 9 holes in between the existing ones or try and locate a smaller rag joint? I see many rear sprockets on this forum that have been drilled for looks, possibly lightening etc. just didn't know if this would be a problem in between the existing hole pattern.
So far four new motorized bicycles are in this neighborhood, and hope to get more involved.
Thanks, Tom
Should I re drill the 9 holes in between the existing ones or try and locate a smaller rag joint? I see many rear sprockets on this forum that have been drilled for looks, possibly lightening etc. just didn't know if this would be a problem in between the existing hole pattern.
So far four new motorized bicycles are in this neighborhood, and hope to get more involved.
Thanks, Tom