Hallo to all.
My new 48cc Noname is apart. I bought a couple of bearings to replace them with better ones. And finally I wanted to balance the crankshaft and true it if necessary.
Now here's my problem:
the flywheels are melted, glued, resined with the main body of the crankshaft. Is it that often? It's a really hard mass around. The 6 screws are also available as usual. How do you remove this mess to get the flywheels off? I didn't find anything about that in the forum. Can somebody please give some tips?
I would not ask if the crank would be balanced properly. But it isn't. I've determined the balance factor. It is rather precise -2% for bad vibrations.
Thank you - Multipaul
My new 48cc Noname is apart. I bought a couple of bearings to replace them with better ones. And finally I wanted to balance the crankshaft and true it if necessary.
Now here's my problem:
the flywheels are melted, glued, resined with the main body of the crankshaft. Is it that often? It's a really hard mass around. The 6 screws are also available as usual. How do you remove this mess to get the flywheels off? I didn't find anything about that in the forum. Can somebody please give some tips?
I would not ask if the crank would be balanced properly. But it isn't. I've determined the balance factor. It is rather precise -2% for bad vibrations.
Thank you - Multipaul