Porting templates

GoldenMotor.com
G

gokart25

Member
Sep 26, 2011
245
1
16
Iowa
On the same topic here... What kind of dremel bit is needed for porting. Does someone have a part number for the bit? Thanks
 
killercanuck

killercanuck

New Member
Dec 17, 2009
1,748
6
0
47
Wallaceburg ON
The easiest way would be to cut your gasket to match the jug, then use that for a template for your intake :) If the gasket is still new, rub a little chain oil on the jug surface, then snug the gasket down under the intake, that'll give you a good "imprint" of the port on the gasket to go by

If you're porting the jug, that's a different can of worms.

gl
 
killercanuck

killercanuck

New Member
Dec 17, 2009
1,748
6
0
47
Wallaceburg ON
gokart, depends on the intake, if its aluminum one of these bits works great pic, but for steel a grinding stone is better, just use a stone small enough to get into the port.

gl
 
You must log in or register to reply here.
Top Bottom