I am thinking of doing a Predator 99cc pusher but would like to do a manual clutch. How do I either do it or where do I buy one??? 
How do I do a manual clutch???
- Thread starter FireEater
- Start date
Easiest thing would be to set up a jackshaft primary drive and use a pully on the engine instead of a centrifugal clutch, and fab a spring loaded idler to press the outside of the slack side of the belt, with a cable and clutch lever to control the idler to disengage the belt. Instead of jackshaft, some have used a bike rim attached to the rear rim for a pully to get a useable ratio, and modded the frame for it.I am thinking of doing a Predator 99cc pusher but would like to do a manual clutch. How do I either do it or where do I buy one???
Search the DIY section . Look at my in-frame Preddy friction drive thread, And Cannonball2 Just posted pics yesterday of his 1905 replica with a belt clutch and Robin engine.
Last edited:
http://motorbicycling.com/showthread.php?t=38597
he has really good pics showing how it tightens the slack
your going to have to use belts and pulleys bro atleast for the clutch part, you can make it hand of foot operated, very cool
he has really good pics showing how it tightens the slack
your going to have to use belts and pulleys bro atleast for the clutch part, you can make it hand of foot operated, very cool
Well that can be done. I have pop cans I can melt and as far as the witchcraft goes I have an ex-wife so that probably has that covered... Thanks Charlie!Melted pop cans and witchcraft
