Ok I have a grubee skyhawk 66cc, NT carb. Was running great. I threw out a bearing in the bottom end. I buy a new one and also decide to add a centrifugal clutch this time around too. After installing everything, it don't seem to be running right. It lacks power and when trying to accelerate it starts shaking really bad. Not vibrations, it's jumping. This could be from the new centrifugal clutch though. Not at the right enough speed yet. It just seems like its bogging just enough to notice. I had to screw the idle screw in all the way just to get it to idle a little. And it still cuts out at idle if left too long. I installed all new gaskets so there should be no air leaks, but I plan on checking this later at work. I shouldn't be the carb because everything worked fine b4.
What I'm looking for is some suggestions to help me trouble shoot the issue I'm having. Thank for your responses.
What I'm looking for is some suggestions to help me trouble shoot the issue I'm having. Thank for your responses.