Decided to try my luck with a different rag-joint sprocket, as I hadn't bored out the middle (this one fits perfectly over my hub) and I figured it'd be easier to center that way. However, when I got the first three bolts on I realized the banana washers on the inside of the wheel slightly overlap. Is that OK?
Pulled the thing off to make sure, and aligned the banana washers together on top of the sprocket. You have to overlap the washers a little and still a few of them are slightly offset (visibility through like 3/4 of the hole). It's strange because I thought there was only 2 different sized rag joints, and this was all sealed together in an unopened package with the sprocket, rag joint, mounting hardware, and banana washers.
BTW: This is the larger size mounting setup. I can tell the difference between the two because my older one was a lot smaller.
Is this just something I should throw away?
Pulled the thing off to make sure, and aligned the banana washers together on top of the sprocket. You have to overlap the washers a little and still a few of them are slightly offset (visibility through like 3/4 of the hole). It's strange because I thought there was only 2 different sized rag joints, and this was all sealed together in an unopened package with the sprocket, rag joint, mounting hardware, and banana washers.
BTW: This is the larger size mounting setup. I can tell the difference between the two because my older one was a lot smaller.
Is this just something I should throw away?