Anyone without a TIG foot control do this...

GoldenMotor.com
ghost_rider

ghost_rider

New Member
Feb 7, 2012
21
0
0
AR
Go to a welding supply or shop that tig welds stainless steel and buy few 1/16" x 36" stainless tig rods, clamp one end to metal table the other to ground clamp the farther down the rod gives less power farther up more power you get.
Be sure to keep away all cords air hose and your self it gets hot.
 
GearNut

GearNut

Active Member
Aug 19, 2009
5,104
11
38
San Diego, Kaliforgnia
That's an excellent idea that no doubt works well.

Whenever I use an automotive battery charger to electrolytically remove rust I use 10 feet of steel rebar wire, connected in series, to act as a high power resistor. It puts a 1 amp load on the charger to prevent the internal circuit breaker from tripping.
 
Last edited:
You must log in or register to reply here.
Top Bottom