I can't figure out where it goes to put it back togethor tho. Thanks so much in advanced.
Imageshack - 0901102016.jpg
Imageshack - 0901102016.jpg
Thanks Kevlarr. Me thinks the OP lives under a bridge and has layers....like an onion....Oh, that's an ogre. My bad. ;>)Dude it's a washer plain and simple. You took it off or it was left loose and rattling around at the factory, asking us what it is then denying the facts when we tell you exactly what it is is kind of like putting 20 oz. of oil in a 4 cycle engine then denying that is the reason why it blew up.
Train wreck.
is the retaining bolt for the bevel gear reverse threaded??
after the first ride i inspected the components&such,,& noticed the bevel gear set itself slightly crooked~untrue to the clutch gear. this has created a small hard start conndition,but it still runs like a raped ape. i have the new gear & woodruff key, Im just having a little trouble getting the screw out. any ideas?
thanX in advance
That washer was on the end of the shaft that has the large sprocket, to take up "sideplay" in the assembly.