Hello!
I am another first-timer, and I need help understanding the directions I have for connecting the coil up. The directions say:
"...Wire Connections...Blue to Blue and Black To Black. Also..Tie Kill Switch to the Blue wire / earth. The white wire is generator and has a max output of .5A 7.5V. Anything that draws more current connected to the white wire will kill the motor."
So I hooked the blue from the coil to the blue on the motor, and the same for the black wires.
Both wires from the coil have two connections, as in two wires can connect to the single wire.
That leaves two spots open - but there are three wires left: One white wire from the motor, and a green wire with a yellow wire from the killswitch. The yellow one has an orange/red stripe.
So far my thoughts are the white wire goes into the second blue wire
I am another first-timer, and I need help understanding the directions I have for connecting the coil up. The directions say:
"...Wire Connections...Blue to Blue and Black To Black. Also..Tie Kill Switch to the Blue wire / earth. The white wire is generator and has a max output of .5A 7.5V. Anything that draws more current connected to the white wire will kill the motor."
So I hooked the blue from the coil to the blue on the motor, and the same for the black wires.
Both wires from the coil have two connections, as in two wires can connect to the single wire.
That leaves two spots open - but there are three wires left: One white wire from the motor, and a green wire with a yellow wire from the killswitch. The yellow one has an orange/red stripe.
So far my thoughts are the white wire goes into the second blue wire