I need to know what the exact spacing is between the stock rear mount holes on a RAW80. I am going to make a mod to stop them from spreading but need the exact measurements. I will post my mod here when i am done.
Rear Mount Spreading
- Thread starter The Busted Nut
- Start date
Not quite sure what you're saying. Are the mount studs spreading? If so then it might be that your seat tube is larger in diameter than most. Please explain.
Dax 80 measures 42mm center to center on the studs (about 1 & 5/8")
Tom
Dax 80 measures 42mm center to center on the studs (about 1 & 5/8")
Tom
