What size are you starting with? (is it 6mm or 8mm?)ok, i over tightened my head bolts and have stripped out my threads down in the crank. What size should i tapp out the threads? PABLO???????????????? lol.
Jeff, I thought you said you had a torque wrench. LOL If you get into big problems give me a call, might have to heli coil it or I can make you some special studs.ok, i over tightened my head bolts and have stripped out my threads down in the crank. What size should i tapp out the threads? PABLO???????????????? lol.
Jeff, You can either go to 8 MM or 5/16. The same size within about .003, just a different thread. I wouldn't worry about trying to find a grade 8 bolt.the bolts are 6mm.
It's simple enough, just paint up a new gasket with (real) aluminum spray paint. Let it air cure a bit and then assemble and torque.i cant seem to find that post pablo. would it not be blowing oil out of head gasket if was leaking? or could i here it? i'm at work when i get home i'll see if i can figure it out. thanks