Still waiting on shipping from Canada Zoombicycles. I have spent countless hours on our forum here and with the knowledgable people here, I believe I now know most of the trick, secrets, to check every pc. of the kit, carb, clutch magneto etc.etc. Yes I purchased two different thicknes of gasket paper and will be tracing gaskets to cut out for spares before any assembly. My big question here is I would also like to make cyclinder base gaskets, but I will need to pull the cyl. off. Will this tear up my original gasket? I defeat the purpose if it does, but my thought is the motor has not been run yet that the gasket may come out intact? Where is a good place to buy allum. so I can also maake spare heaad gaaskets? Thanks Jim