View Single Post
Old 06-26-2009, 05:14 PM
BrettMavriK's Avatar
BrettMavriK BrettMavriK is offline
Motorized Bicycle Elite Member
Join Date: Oct 2008
Location: Tampa Bay, FL
Posts: 390
Default Re: BrettMavrik's Production Bobber Frame For Builders Has Begun...

Hey Thanks!

Terron, as I wrote in the other posts, I will have to finish this bike first...
Then I can determine the costs, and forecast orders for quantity pricing of materials.
I won't have an answer until then. I will also need to R&D this design to make sure it is tried and true.
Dad, I will have more detailed photos once everything is cleaned up and presentable.
Right now, everything still has rough edges and weld smoked. Yes very simple design on the tubing clamps. An old age clamping system that is very effective. The smaller tubes are welded on each side all paralell. Then the entire unit is "halved" down the middle. The result is a hand made clamp that fits extremely snug and could hold back an 1100 cc engine.

My Production Bobber Build Up
"Everything Is Possible...If You Can See Beyond The Invisible"

Last edited by BrettMavriK; 06-26-2009 at 05:23 PM.