I purchased a crankcase seal from a dealer that deals mostly with Skyhawk engines. I installed it but it doesn't seem to fit snug behind the magneto magdet. Is there a difference between the seals for each engine or could I possible have purchased the wrong seal?
This is the one I had ordered and installed. It shows This is a direct OEM replacement and will fit either a 48cc or 66cc motorized bicycle and is guaranteed to last.
Could it be the clutch side then? http://www.motorizedbicycle.ca/crankshaft-parts/202-seal-loop.html
I'm not suggesting one vendor over another but just linking this page to you so you can see a comparison between the thick and thin seals. http://www.pistonbikes.com/category-s/10.htm Most of our advertisers carry these seals.
The thinner one goes behind the magneto rotor; the thicker one behind the primary gear on the right side.
2Door. Thanks for that link. To bad they don't ship to Canada. I'll have to Google and see what other shops there are. I may check a few small engine shops in my area to see if they might have one.