Re: It Ain't the Spark Plug !
There is no ignition timing, it is set in place by a key on the shaft, now if the key is partially sheared that would change the timing. I read a post that someone had an armature where the air gap was too wide, and he closed it with channelock pliers. When I was jetting my carb I came across a similar problem got it running fine in the garage but when I rode it it bogged real bad, turned out to be too small a jet, you might try moving the needle clip down one slot and richening the air/fuel mix, or check that the jet is not plugged...
"No such thing as a stupid question, just a stupid answer"
48cc Grubee Starfire Round Head......
Last edited by misteright1_99; 09-28-2008 at 09:49 PM.