Thread: needle clip
View Single Post
Old 07-08-2008, 07:31 PM
Pablo's Avatar
Pablo Pablo is offline
Master Bike Builder & Forum Sponsor
Join Date: Dec 2007
Location: Duvall, WA PNW
Posts: 3,649
Default Re: needle clip

So have you actually ported your engine?

Or just matched the stock exhaust to the port? Or did you get an expansion pipe?

Same with intake? Port/gasket/manifold all match?

Is your engine well broken in? How many full tanks of fuel have you used?

Have your jets arrived? Have you measured your stock jet?

I need a better baseline - because it's quite odd going two clicks rich makes it run better. Especially at WOT.
Reply With Quote