whats the gap on my new bp6rhs?

Discussion in 'Motorized Bicycle General Discussion' started by toker_ace, May 24, 2009.

  1. toker_ace

    toker_ace Member

    Joined:
    Oct 15, 2008
    Messages:
    475
    Likes Received:
    1
    I just installed my new slant head with a new ngk bp6rhs plug.I used two head gaskets.TO be honest, I really didn't notice that much difference.Maybe, a little but not $29.00 worth.Anyhow, what is the gap need to be set at? thanks
     
  2. Pablo

    Pablo Master Bike Builder & Forum Sponsor

    Joined:
    Dec 28, 2007
    Messages:
    3,652
    Likes Received:
    0
    .020 - .025"
     
  3. toker_ace

    toker_ace Member

    Joined:
    Oct 15, 2008
    Messages:
    475
    Likes Received:
    1
    Hey Pablo. What causes all that ratting and pinging when I am just idol? I believe its in the clutch area. When I let the clutch out it practically stops.When I pull in the clutch it sounds like everything is rattling and pinging. thanks
     
  4. Pablo

    Pablo Master Bike Builder & Forum Sponsor

    Joined:
    Dec 28, 2007
    Messages:
    3,652
    Likes Received:
    0
    Chinese Idle. .duh.:-||laff

    The rattling is most likely the engine turning the flywheel gear with no load. Nothing in that nether region is anything I would call precise. The floating gear could be making some gentle contact, could be the bearings, etc....try it with the cover off. Just for fun.
     
  5. toker_ace

    toker_ace Member

    Joined:
    Oct 15, 2008
    Messages:
    475
    Likes Received:
    1
    so just take the 4 screws out? i will not have a clutch will i? I'm confused. lol
     
  6. Pablo

    Pablo Master Bike Builder & Forum Sponsor

    Joined:
    Dec 28, 2007
    Messages:
    3,652
    Likes Received:
    0
    No just take the cover off. 5 screws on a stock bike.
     
  7. toker_ace

    toker_ace Member

    Joined:
    Oct 15, 2008
    Messages:
    475
    Likes Received:
    1
    you so smart! yea i guess that is chinese idle. Its funny with the cover on it sounds like the noise is coming out on the sprocket side. I don't guess there is anyway to stop that rattling,huh? sure is a high pitch rattle.
     
  8. Pablo

    Pablo Master Bike Builder & Forum Sponsor

    Joined:
    Dec 28, 2007
    Messages:
    3,652
    Likes Received:
    0
    High pitch? It may be contacting the case or the cover. Mine did! Eventually it stopped.
     

Share This Page