Rear Mount Spreading

Discussion in 'Motorized Bicycle General Discussion' started by The Busted Nut, Aug 10, 2011.

  1. The Busted Nut

    The Busted Nut New Member

    Joined:
    Aug 2, 2011
    Messages:
    96
    Likes Received:
    0
    I need to know what the exact spacing is between the stock rear mount holes on a RAW80. I am going to make a mod to stop them from spreading but need the exact measurements. I will post my mod here when i am done.
     
  2. 2door

    2door Moderator
    Staff Member

    Joined:
    Sep 15, 2008
    Messages:
    16,301
    Likes Received:
    26
    Not quite sure what you're saying. Are the mount studs spreading? If so then it might be that your seat tube is larger in diameter than most. Please explain.

    Dax 80 measures 42mm center to center on the studs (about 1 & 5/8")

    Tom
     

Share This Page