most of yall know me by now...

Discussion in 'Motorized Bicycle General Discussion' started by charles.paskell, Jun 2, 2010.

  1. charles.paskell

    charles.paskell New Member

    Joined:
    Feb 25, 2010
    Messages:
    201
    Likes Received:
    0
    Well I have another problem it seems that i need a new bucking bar mine wore out and is not allowing my clutch to Disengage I dont like riding without my clutch but am forced to as its my only way to get around. i have to say without my clutch being able to disengage, riding its a little sketchy
    but i guess it could be worse if the clutch would not engage . what im trying to say is i need a new or slightly used bucking bar and cant afford to pay for the part and shipping im hoping someone had a spare and could send it to me for the cost of shipping I know i ask alot from this forum but isent that what its here for? maby not but i see people doing trades and things of that nature on here all the time
    i dont know what to do im at a loss maby someone could tell me a good way to fix this problem with little to no money I was thinking of getting some liquid steel and put a glob on the bucking bar to make up for the clearance issue i dont know,dose any one trust liquid steel?
     
    #1 charles.paskell, Jun 2, 2010
    Last edited: Jun 2, 2010
  2. Bikeguy Joe

    Bikeguy Joe Godfather of Motorized Bicycles

    Joined:
    Jan 8, 2008
    Messages:
    11,529
    Likes Received:
    3
    Remove the bar that goes into the clutch, the one that sits on the ball bearing in there, and take it to Lowe's or Home Depot and get another one, just a couple mm longer.
     
  3. charles.paskell

    charles.paskell New Member

    Joined:
    Feb 25, 2010
    Messages:
    201
    Likes Received:
    0
    sweet i will try that thanks
     

Share This Page