Major clutch arm problems

Discussion in 'Motorized Bicycle General Discussion' started by J money gta, Feb 21, 2010.

  1. J money gta

    J money gta New Member

    Joined:
    Feb 20, 2010
    Messages:
    3
    Likes Received:
    0
    My clutch arm moves around freely and doesn't hit against anything. So of course its not starting, I have the grubee skyhawk 66/80cc engine that I bought from bikeberry, back around three months ago. But I'm a pretty big noob, because I'm only 16 and have no clue about these engines.
     
  2. Bikeguy Joe

    Bikeguy Joe Godfather of Motorized Bicycles

    Joined:
    Jan 8, 2008
    Messages:
    11,529
    Likes Received:
    3
    There is a ball bearing and a rod that should be inside the sprocket.

    Remove the left cover (drive side) and look up in the center of the sprocket...are they there?
     
  3. J money gta

    J money gta New Member

    Joined:
    Feb 20, 2010
    Messages:
    3
    Likes Received:
    0
    No, but I do hear a lot of rattling when I pick up the engine
     
  4. Bikeguy Joe

    Bikeguy Joe Godfather of Motorized Bicycles

    Joined:
    Jan 8, 2008
    Messages:
    11,529
    Likes Received:
    3
    There should be a rod, with a ball bearing behind it. They can't go inside the engine, but they can fall out if you took the cover off and were unaware that they were in there.
     
  5. J money gta

    J money gta New Member

    Joined:
    Feb 20, 2010
    Messages:
    3
    Likes Received:
    0
    Well there's my problem, is there anyway that I couldgo to like bikeberry.com and get replacemet parts, it is it maybe included in the warranty??
     
    #5 J money gta, Feb 22, 2010
    Last edited: Feb 22, 2010
  6. Bikeguy Joe

    Bikeguy Joe Godfather of Motorized Bicycles

    Joined:
    Jan 8, 2008
    Messages:
    11,529
    Likes Received:
    3
    They should be available from any vendor, if the guy who sold you the kit doesn't have any, call around.
     

Share This Page