Kill switch

Discussion in 'Motorized Bicycle General Discussion' started by eugesd, Jun 7, 2009.

  1. eugesd

    eugesd New Member

    Joined:
    Jun 7, 2009
    Messages:
    19
    Likes Received:
    0
    I am confused, i follow the instructions in the manual (blue to blue, black to black, white to yellow, black to ground) and the engine doesn't shut down? Can someone show me a correct digram.
     
  2. Cabinfever1977

    Cabinfever1977 New Member

    Joined:
    Mar 23, 2009
    Messages:
    2,290
    Likes Received:
    1
    that is correct,maybe its not grounded good enough.
     
  3. Junster

    Junster New Member

    Joined:
    Jun 2, 2009
    Messages:
    445
    Likes Received:
    0
    Your motor isn't grounding to the frame well. Just run one kill switch wire to the white and the other to the black that's going to the cdi also. It doesn't matter which kill switch goes to which one. The switch just grounds the two wires together.
     
  4. cabbiex5

    cabbiex5 New Member

    Joined:
    Feb 12, 2009
    Messages:
    47
    Likes Received:
    0
    could be your idle also, my killswitch didnt work until i got my idle at the right mark
     
  5. eugesd

    eugesd New Member

    Joined:
    Jun 7, 2009
    Messages:
    19
    Likes Received:
    0
    the way i described it or this [​IMG]
     

Share This Page