clutch assembly jam, wont disengage

Discussion in 'Norm's 2 stroke repair center' started by bike, May 24, 2010.

  1. bike

    bike New Member

    Joined:
    May 24, 2010
    Messages:
    2
    Likes Received:
    0
    I was pedaling my bike and before I could engage my motor the drive chain jammed. Now the clutch will not disengage and always driving the chain/motor. I removed both the clutch and drive sprocket they appear fine. The ball bearing clutch arm does not push the clutch plate out. Does anyone have any ideas to resolve the issue short of splitting the case?
     
  2. Norman

    Norman LORD VADER Moderator
    Staff Member

    Joined:
    Jan 16, 2008
    Messages:
    2,605
    Likes Received:
    0
    look at my sticky on engine tear down and on the clutch for info on your clutch system.
    You do not need to split the engine case to remove the shaft. I refer to it as the main shaft this is the shaft that has the clutch on one end and the sprocket on the other end with the clutch rod in the center.
    If you will take the time to look through the stickys it will give you the info you are looking for.
     
  3. lloydchess12345

    lloydchess12345 New Member

    Joined:
    Jun 22, 2010
    Messages:
    1
    Likes Received:
    0
    were are your stickeys
     
  4. Norman

    Norman LORD VADER Moderator
    Staff Member

    Joined:
    Jan 16, 2008
    Messages:
    2,605
    Likes Received:
    0
    look at all the posts in Norms 2 stroke repair center . If you are reading this click the back arrow top left hand side now you are looking at all the posts the first few are all sticky's with how to repair info in each one with photos all you need to do is look. All posts above yours is a sticky they all start with the word sticky.
     

Share This Page