Car carrier for motorized bicycles - recommendations?

Discussion in 'Motorized Bicycle General Discussion' started by Nougat, Mar 18, 2011.

  1. Nougat

    Nougat New Member

    Joined:
    Nov 4, 2009
    Messages:
    1,332
    Likes Received:
    0
    Re: Car carrier for MBs - recommendations?

    Before I looked at the picture, I thought you were describing a hitch pin that went through the square tube, and through the round tube.
     
  2. Dan

    Dan Staff
    Staff Member

    Joined:
    May 25, 2008
    Messages:
    12,495
    Likes Received:
    50
  3. corgi1

    corgi1 New Member

    Joined:
    Aug 13, 2009
    Messages:
    2,282
    Likes Received:
    1
    Re: Car carrier for MBs - recommendations?

    Is it made w/old bed rails?(center track welds)
    and the pivot in the actual hitch is better than how I first thought .looks better all the time. .weld
     
  4. 2door

    2door Moderator
    Staff Member

    Joined:
    Sep 15, 2008
    Messages:
    16,301
    Likes Received:
    26
    Re: Car carrier for MBs - recommendations?

    Quote: Is it made w/old bed rails?(center track welds)

    LOL. No Corgi, it's 1 1/2" angle iron welded together.
    Couldn't find any old bed rails. They might have been cheaper, though.
    About $40.00 worth of steel from Home Depot. I aleardy had the hitch pin, square tubing and the 1 1/8" round stock so that was free. I saw a motorcycle carrier on Craig's List, non-tilt, for $140.00 so I came out better on the money end. Saved a hundred. :)
    Tom
     

Share This Page