Advice Needed/Chain Guard/Motor Mount Problem

Discussion in 'Motorized Bicycle General Discussion' started by OilyDave, Apr 4, 2010.

  1. OilyDave

    OilyDave New Member

    Joined:
    Mar 21, 2010
    Messages:
    6
    Likes Received:
    0
    I mounted the engine onto the Cruiser Bike that I have but I cannot get the chain guard to fit as the motor sits very low and there is not enough room for the top part of the chain guard to slide in.

    I think that I need to have the motor mounted higher on the frame to allow for clearance of the chainguard. Is there motor mount shims or motor mount extenders that I can buy to attach so that the engine will sit snug higher up on the frame?

    Thanks
    Dave
     
  2. GoFastBicycles

    GoFastBicycles New Member

    Joined:
    Jul 29, 2008
    Messages:
    560
    Likes Received:
    0
    Chain guard is not that big of deal. If the motor is installed and every thing is good dont fuss with it for the guard.

    Adam
     
  3. Dave31

    Dave31 Moderator
    Staff Member

    Joined:
    Mar 1, 2008
    Messages:
    11,207
    Likes Received:
    14
    Sometimes I notch the guard mounting holes so I can have a little more adjustments
    to lower the chain guard.
     
    #3 Dave31, Apr 4, 2010
    Last edited: Apr 4, 2010

Share This Page