About to begin my first project

Discussion in 'Pre-Motorized Bicycle Information.' started by NickM357, May 29, 2016.

  1. NickM357

    NickM357 New Member

    Joined:
    May 29, 2016
    Messages:
    3
    Likes Received:
    0
    Hey guys, so like the title suggests, I'm about ready to begin working on my first bike. I'd like to mount an engine to my Diamondback Response, but I'm not 100% sure what engine would be best or how I'm going to mount it. So far, I'm thinking a rear-mounted friction drive is my best bet, because I don't believe I have enough clearance in the center of my frame to mount one there. Any suggestions or advice?
     
  2. Venice Motor Bikes

    Venice Motor Bikes Custom Builder / Dealer/Los Angeles

    Joined:
    Mar 20, 2008
    Messages:
    6,168
    Likes Received:
    16

Share This Page