Separate names with a comma.
Did it run?
You will have to experiment to find out about power but the top notch is pretty lean.
I would say it's leaner or has less oil in the mixture than I would run in mine.
It may be easier to replace both cylinder and piston if this set fits. There are many of these on eBay so look at a few.
Probably the suggestion of of clear coat is good. Then you can use the paint you are used to using.
About how much did you have to pay for the...
Check to see if y get fuel flow out of the tank. Some tanks come with lots of junk in them.
If you think it flooded turn off the fuel and see if...
Not saying this will fit but think it’s likely. For $30 not too much risk....
The only part that will move the sprocket position is the rag joint material between the sprocket and the spokes.
I will add some thought on this. That 6 bolt wire is almost certainly AC voltage and isn’t regulated to 6 volts in any way. I would get two large...
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] I have shortened one mount and notched another to get the motor sitting lower in the frame. Worked...
[ATTACH] I did put suspension forks on it. Pretty happy now.
Does it look like this?
Haha. Don’t hold your breath until you get it.
Thinning the outer material won’t move the sprocket position.
I don’t think it’s 25mm. 25mm is about an inch and yours looks like about an inch and a half.
I would look at using a red led and a current limiting resistor of some kind. Or a led light bulb for a turn signal. If you draw too much from the...