Separate names with a comma.
A 'Rocket Key'. can be made from filing a wider key (clutch key) down. I'd post a photo, but I'm over how much of a pain it is to post photos on...
I would try and get a couple of magnets, I have 3 different style of magnets, and have noticed a difference with the 'better' ones.
The good ones...
I have all the parts here to build an adjustable CDI as well as parts and a circuit for a small LED timing light. I think that if your timing is...
This has been stated before, but there are a couple of different Magnets, with different keyway locations.
From what I have been told 20 deg is...
When making silver jewelry, often the piece is wired together before silver soldering to hold all pieces in place.
Maybe similar could be done?
I believe there is a trick involving using a little chalk, the chalk will discolour Just before the alloy 'drops'.
Looks like from an angle grinder to me.
My Torque pipe, which was not perfect, but made my bike wheelie also, with a nice boost as low as 4000, however limited my revs to around 8500,...
Base gasket will also alter readings, but you know that.
Havn't measured squish of stock barrel, not real mobile today.
Stroke is 32mm.
Taking a 'rough' measurement (steel rule) of the stock barrels, I have transfers again at 27.5mm. But Exhaust at 23.5mm. I'm not entirely sure...
Fixed drawing, ankle might take a little longer.
Did it yesterday lunch time, was not thinking clearly when I posted it up this morning,
I see my mistake now, transfer should be 27.5mm not 22.5, My bad writing, lol. Was 4.00 AM with a sprained ankle and pain killers ,still a little...
Just noticed I put boost port and transfer port measurements in wrong spots, lol.
Photoshop worked this time?
Is that what your after?
Frank, do you Face book?,
Much easier than this Forum.
Otherwise, PM me your Email.
Starting with the Boost ported barrel, cause it's the easiest, lol.
Hope this is what your after? Pic of Deck height, is without base gasket....
Have stock 40cc, stock 49cc, and boost ported 'Big bore Kit (49cc) Barrels on the bench. But can't find a sheet of graph paper, 'on to it' though,...