Separate names with a comma.
Hi, yes it spins.
Unfortunately, I can't seem to budge the screws on the manual side. Any tricks for that?
Hi guys, I had a pull start - Centrifugal clutch on my 2 stroke.
It was working fine for a while but will not drop into gear now. It starts...
Hi, the motor runs but the spindle piece that is supposed to drive the wheel does not spin? Any suggestions on what this could be?
Thanks for everyone's help and comments. Much appreciated!
Does anyone know who manufactures this friction drive?
motor bicycle gas engine rear friction kit 49cc RF49 | eBay
I am trying to source a...
I am confused by the measurements. I found a 1/4 - 18 tap but it is much smaller than the drilled hole of 7/16 ?
Hi, I was looking at a past thread about the steel bottle tanks. Did you have any issues with the pressure building up with the fuel?
Hi, I will confirm the oversize mount. I have installed three of these on the oversized frame of the 29er that Walmart sells (I know, I know) . It...
Thanks for all the interest guys, quite humorous thread, but I couldn't let it go for that little. I know that no one in the country has these in...
I have one I decided not to assemble. Anyone interested in taking off my hands?
That's how I thought about doing it, but am worried I would affect the integrity of the frame.
Hi, the upper tube is too large to use traditional mount. Does anyone have any suggestions for an alternative?
I cringe to ask, but it's the...
It seems everywhere I look I can only find the GT1 bicycle in stock. Does anyone know who has the in-tank GT2 Version in Stock?
Hi, I have an oversized mount on the engine. The mounts are wide enough, but the curve does not match with the tube. Therefore it would have a...
Here is the product...