Separate names with a comma.
thanks a load, dude! I’m gonna do both those things. Say you don’t layer on the Teflon tape? You just put one little layer?
Thanks for your help. I figured that could have been a potential cause, but where do you usually see these sorts of leaks if you don’t mind me asking?
Loctite is also a good idea, I’ll use that!
I’m gonna try the inner tube as that is available to me. Thank you!!
hey guys, so my first build i ran it and the engine idled flawlessly. For a while, then the bike would no longer idle. When I pull the clutch the...
HEY GUYS! Just built my first beauty. It’s running well and strong aside from when I picked up a nail. However I have a question about how you...
ey!! I actually got it running! It turned out to be a bad magneto this I wasn’t getting any spark. Now however I’m seeing components such as...
Like I mean the brass clamp that hold the carburetor on is set by a pin that holds it in its place. ♂️
Im not sure where this ramp that needs to be to the idle screw is. :(
Carb/ throttle connection
Okay! I will do! I’ll let ya know in The morning! thanks!
The gas cap was not closed properly and I’ve fix that but sadly the issue still stands. :(
You’re talking about the gas tank cap? Just need to verify. XD that may be it!
Like the en
like The engine will turn over when I drop the clutch but as the bike slows down it just dies out. :/
Hey there, I’m having the same problem as Dirty Patches, only my carb is at the right angle. I was wondering if you can’t give me a little advice?
I’ve just built my first bike, and it starts and runs but slowly dies. The throttle works but doesn’t push the bike and, it just kicks up...
Hey it all worked! Now it starts but when I start it it slowly dies away. If I give it throttle it works too but that dies down as well. :/ can ya...
Thanks! For your help.
And it worked!! But now I see that the drive sprocket May have some rough edges. I think the chain is trying to buckle over unless I roll very...
I have done that process once before, but I will try it holding the clutch bar instead of the clutch handle. Thanks!