This is going to be a little hard to explain..but here we go
1) the clutch was working fantastic up untill the ball bearing fell out (DIA 8 Steel Ball) i placed it back into the shaft and figured everthing would be just fine (yes i did lube it with bearing grese)
2) the Cam pin has a divot on it (pictured below)
http://i.imgur.com/6SrRX1i.jpg
3) the bucking bar has a worn out spot on it as well (pictured as well)
http://i.imgur.com/FsPjXfe.jpg
4) when the whole thing is assembled the clutch arm goes from 4pm to 2pm and gets stuck. any ideas what could be the solution to this problem??
http://i.imgur.com/T60zEEq.jpg http://i.imgur.com/rm98LWp.jpg
1) the clutch was working fantastic up untill the ball bearing fell out (DIA 8 Steel Ball) i placed it back into the shaft and figured everthing would be just fine (yes i did lube it with bearing grese)
2) the Cam pin has a divot on it (pictured below)
http://i.imgur.com/6SrRX1i.jpg
3) the bucking bar has a worn out spot on it as well (pictured as well)
http://i.imgur.com/FsPjXfe.jpg
4) when the whole thing is assembled the clutch arm goes from 4pm to 2pm and gets stuck. any ideas what could be the solution to this problem??
http://i.imgur.com/T60zEEq.jpg http://i.imgur.com/rm98LWp.jpg