Recent content by Crysisfreak7

  1. C

    2 stroke to 4 stroke conversion phase questions

    If i have the entire kit that came with my 2 stroke engine, and wanted to get a 4 stroke, could i just get the engine and use all the parts i still have, sprocket, throttle, clutch, everything, on the new engine. and if so, would i go any slower or faster with the sprocket that came with the 2...
  2. C

    broken threaded rods

    where can i find this extractor tool, and can i buy two threaded rods from you?
  3. C

    broken threaded rods

    the threaded rods on the front of the engine for mounting have snapped and i am wondering how to get them out. they are snapped off slightly inside the engine block, could i drill a hole in them then use a screw to grab it and unscrew the rod? also where can i get more threaded rods like this.
  4. C

    engine gets LOUD at full throttle

    what would best, leaning more towards the front bar, or more towards the back bar? (more towards the handle bars or the back wheel)
  5. C

    engine gets LOUD at full throttle

    my previous bike was a superlight, the new one is a beach cruiser
  6. C

    engine gets LOUD at full throttle

    i recently moved the engine to a new bike, and when i hit full throttle, the bike vibration increases dramatically, and it sounds like sometihng is rattling around. this didnt happen on the other bike. it doesnt seem to do this while reving but i cannot be sure. and it only happens when i reach...
  7. C

    pullstarter or no on my cruiser

    but you are absolutly sure that the spokes wont snap, my racing bike spokes snapped, just while i was riding normally.
  8. C

    pullstarter or no on my cruiser

    I just bought a Panama Jack Huffy Cruiser, and i have a pull starter that blocks the pedals, and with coaster breaks that is a problem. Would the spokes be ok on a cruiser like this when starting the engine the normal way (take off, reach a certain speed, then release the clutch)?
  9. C

    permatex timing

    would starting and idleing atleast help?
  10. C

    permatex timing

    is it safe to ride my bike after only 1 hour of waiting for permatex super copper to dry?
  11. C

    muffler gasket blowout

    the rubber gasket that was between the muffler and engine fried on the bottom. my bike sounds like a dirtbike now, should i leave it this way (i doubt it), and could this be caused by the fact that my pedals brush the muffler when i pedal. it causes the muffler to tilt up a bit, but it then...
  12. C

    gas guzzler?

    gas guzzler? part 2 the previous gas guzzler thread had en expired token (or something). this is the answer to all the questions that were asked. i think it is so low on fuel because i ride it rather fast, and because i left the valve open frequently (once all night). i dint think the carb...
  13. C

    gas guzzler?

    ok, so from what i just heard, the tank is empty because i forgot to shut off the valve, and because it is still in the break in period
  14. C

    gas guzzler?

    i did also commonly forget to turn the fuel valve off, could this be why?
  15. C

    gas guzzler?

    i filled the half gallon tank a few days ago, and since have gone maybe 20 miles probably alot less. but the tank is almost empty. the only thing i can think of that is unusual is that i had the fuel valve pointing in the opposite direction from on, i thought this was also on. why is my engine...