Recent content by brentemmons

Were is the best place to get a hot cam and heaver sping for the briggs motor ??

Bad news my motor wouldnt start on the wood splitter(5hp briggs 25 years old) so I took the honda off the bike to get it going.It worked out great and runs sweet,now I think I will rebuild the Briggs 5 hp and make a all american heavy huffy.The bike,motor and drive was made in the USA why not...

I just found this other post,I noticed you used a second jackshaft to aline the rear sprocket(I had asked you about you jackshaft plate now I understand your setup).That set up is the bomb,are you going for a land speed record,great work. dnut I was thinking I may have to do the same thing...

I was looking for the red clutch/jack shaft plate you have in the picture. I got a tork coverter drive but the spocket is inside behind the clutch and I want to move it to the back side of the plate to line up with the rear sprocket so I dont need one more jack shaft to transfer the chain.I...

I had some time today and had to got into work to do my chores so I put the bike in my truck.I remove the stock muffler and broke both studs off so I drilled them out.Next I made a exhast manifold plate and tig welded the pipe on.After that I placed the motor in and marked the mounts removed...

Were can I pick one of these plates up?do you have a link or some thing.

Hey Scotto this is realy heavy now I dont think you could thow it very far.LOL Were did you get that backing plate for you clutch on you new build?Was that a hole kit or can you just get the plate? dnut

Well I got about 500 miles out of the 2 smoker and it broke a ring on the way home from work.This was my first MB and I had a learning curve and think I tweeked it out to much also had problems with the gen 2 carb that I finaly thew out and got a good carb. .wee. I am going to recycle this...

I think the uni-strut mounts will work good,I am going to trim them up a bit then paint them.The motor has about 1/2" of room on top,plenty of room for the muffler.I cant wait to try this out.I was thinking about using the carb from my HT motor with a bigger jet and takeing out the govener. dance1